Adding An Airtag Into A G2 BatteryUpdated a year ago

Notes Before Getting Started:

• Read these instructions entirely to understand the steps needed to perform the task.
• You will need a T15 screwdriver to remove the battery handle. This can be purchased from your local hardware store.
• You will need a No. 00 Phillips screwdriver, which can be purchased from your local hardware store, to open the AirTag cover.

Please click here for instructions if you need help connecting the Airtag to your iPhone.

Removing the Battery Handle

• Locate the two bolts on each side of the battery handle and remove them using the T15 screwdriver.
• Set the bolts aside for when you’re ready to re-install the handle.
• Slide the handle up and away from the battery.

Removing the Cover and installing the AirTag

• Using the No. 00 Phillips screwdriver, remove the two bolts on the AirTag slot cover.
• Press the screwdriver down firmly and begin to unscrew the screws. Be sure always to keep firm pressure when unscrewing to prevent stripping.
• Once the screws are removed, remove the AirTag cover.

Re-Installing the AirTag Cover

• Place the AirTag in the compartment and put the cover plate back on the battery.
• Put the two screws back in and use the No. 00 screwdriver to re-install them. Be sure always to keep firm pressure when screwing the screws back in.

Re-Installing the Battery Handle

• Slide the battery handle back on the battery and line up the grooves first.
• Then, place the two bolts back on each side of the handle and fully tighten them with the T15 screwdriver.