Note: The video Assembly is at the end of this FAQ
Start by locating all the items needed for the install
You don't need to remove the rear wheel to do the install but you can if you prefer. If you keep the rear wheel installed, we recommend deflating the rear tire so you can easily fit between the tire and the inside part of the fender.
Start with installing the fender inside the bike.
Then, using one of the round head Allen screws(mushroom) and the flat washer secure it into place by screwing from the inside of the fender towards the threads on the frame
Here is the view for the bottom screw.
And here is the internal view of the top screw
Now you can secure the rear part of the fender by attaching both sides of the wire loop extension
Here is the view of the right side. You will use the short Allen screw and its washer on this side
For the left side, you will replace the security tab screw with the longer one and its washer
Here is the final view.
Once you screw both loops on the wire extension you can adjust the fender position.
Now slowly rotate the rear wheel to see the fender is clear. You can continue adjusting the fender and then tighten everything to keep it in place.
Roll your bike slowly to see everything is attached properly.