Note: The video Assembly is at the end of this FAQ
Start by locating all the items needed for the install
Start with installing the wire loop on your front fender. You will need the wire loop extension, the 2 part holder, and 2 screws.
There are 2 holes located on the rear of the fender. The 2 part holder goes on top (the metal piece with loop) and inside the fender (the metal piece with threads).
Install only the top screw partially so you can then insert the wire loop between the fender and top piece. Now you can add the second screw and secure the wire extension in place.
For the next step we recommend removing your front wheel, then the headlight, and its bracket. You will use the headlight bracket screw to secure the top tab on your fender.
Now you can place the fender while keeping the top fender tab in front of the fork and sliding it all the way to the top for added clearance.
You can install the light bracket now and adjust the fender position before tightening things up.
Now you can install the headlight.
There are 2 tube clamps that go on each side of the fork legs. These will hold both ends of the wire loop extension and keep your fender rear in place.
The plastic tube clamps need to be installed with the flat part on the inside of the forks and pointing towards the back of your bike.
Once you screw both loops on the wire extension you can adjust the fender position.
Now securely install the front wheel and rotate to see the fender is clear. You can continue adjusting the fender and then tighten everything to keep it in place.
Roll your bike slowly to see everything is attached properly.
Link: How do I install the rear fender on my Scrambler
Comments
0 comments
Please sign in to leave a comment.